Attention problem
1. After the room is just paving the wallpaper, the doors and windows should be closed and dried. Because of the immediate ventilation of the room where the wallpaper was just finished, it will cause the wallpaper to squish and kick.
2. After wallpapering for 3 days, use a damp towel to gently wipe away the wallpaper glue left at the seams of the wallpaper.
3, wallpaper more resistant to scrub, but does not resist the blunt bump, if you find a small surface damage, can be used near the color of paint or paint remedies.
4, non-concave wallpaper, weekdays just use a feather duster to clean.
The color of a typical bedroom is preferably warmer and softer to facilitate rest. If the color of the furniture is heavy, the color of the wall should be very light; if the furniture is light, the wall should be set off with a similar contrasting color to the furniture. The color of the newlywed bedroom can be festive, soft and warm. The best color of the curtain is close to the color of the wallpaper, and you must avoid the cold tone.
Maintenance notice
1) During the construction, the construction should be conducted in a season where the relative humidity of the air is less than 85% and the temperature should not drastically change. Avoid construction during wet seasons and wet walls.
2) During construction, doors and windows should be opened during the day to maintain ventilation; doors and windows should be closed at night to prevent moisture from entering. The wall paper that has just been affixed to the wall is prohibited from being blown by strong winds, which will affect its surface fastness.
3) The adhesive solution that overflows when pasting wallpaper wallpaper should be wiped clean with a clean towel at any time, especially the glue marks on the joints, and it should be handled cleanly. This must be carefully and carefully viewed by construction personnel or supervisors. The construction personnel will keep their hands and tools clean. If they are stained, they should be cleaned with soapy water or detergent.
4) Wallcovering foam wallpaper is easy to accumulate gray, affecting the appearance and cleanliness, cleaning once every 3 to 6 months. Use a vacuum cleaner or brush to scrub with water, taking care not to infiltrate water into the joints.
5) Do not use good wallpaper and pay attention to prevent hard objects or sharp objects from scratching. After a certain period of time, cracking of joints in some places must be subsidized in a timely manner and cannot be allowed to develop.
6) The wallpaper of the bathroom should be opened in time when the water droplets and water vapor are hung on the wall and the exhaust fan should be opened in time. Or use a dry towel to wipe the clean water first, because in the long term, the quality of the wallpaper will be damaged, and white spots will appear. bubble;
7) Too dry rooms should be opened in time to avoid direct sunlight for too long, otherwise it will have a negative impact on dark wallpaper colors.
Maintenance of wallpaper blistering: Wallpaper blistering is a common problem, mainly due to the inconsistent application of glue when the wallpaper is pasted, which results in some internal bubbles appearing in the later period when the surface of the wallpaper shrinks and the base layer separates the water from excess water. In fact, the solution is very simple, as long as the general sewing needle to the surface of the wallpaper to pierce the bubbles, the gas released, and then use the needle to extract the right amount of adhesive injected into the pinhole, and finally the wallpaper back to flatten, dry You can.
The wallpaper is moldy: The mildew in the wallpaper usually occurs in the rainy season and wet weather, mainly because the wall moisture is too high. The solution for wallpapers that are not too bad for moldy conditions is as follows: Wipe with a white towel with a proper amount of water, and then wipe it with soapy water. The best way is to go to a wallpaper shop to buy a special fungicide.
Wallpaper Alice: Edge Alice may be the base layer is not clean, adhesive adhesive strength is too low or the angle of the edge of the wallpaper is less than 2mm and so on, the solution: use wallpaper glue.
Scrubbed wallpaper: Use a damp cloth or a dry cloth to scrub the dirty place; you can't use some colored raw materials to contaminate the wallpaper, otherwise it will be difficult to remove; wipe the wallpaper should start at some evasive corners or hidden behind the door to avoid the occurrence of bad The reaction caused damage to the wallpaper.
Cleaning tips
1, vacuum cleaner;
2, diluted detergent, can also be injected into the sprayer;
3. Spray cleaners thoroughly on the wallpaper;
4, the role of 10 to 15 minutes, the stain from the fiber;
5. While cleaning the wallpaper, use a suction machine to suck the washed wallpaper;
6, let the wallpaper completely dry, in order to speed up the wallpaper dry, you can start the wallpaper dryer
1. After the room is just paving the wallpaper, the doors and windows should be closed and dried. Because of the immediate ventilation of the room where the wallpaper was just finished, it will cause the wallpaper to squish and kick.
2. After wallpapering for 3 days, use a damp towel to gently wipe away the wallpaper glue left at the seams of the wallpaper.
3, wallpaper more resistant to scrub, but does not resist the blunt bump, if you find a small surface damage, can be used near the color of paint or paint remedies.
4, non-concave wallpaper, weekdays just use a feather duster to clean.
The color of a typical bedroom is preferably warmer and softer to facilitate rest. If the color of the furniture is heavy, the color of the wall should be very light; if the furniture is light, the wall should be set off with a similar contrasting color to the furniture. The color of the newlywed bedroom can be festive, soft and warm. The best color of the curtain is close to the color of the wallpaper, and you must avoid the cold tone.
Maintenance notice
1) During the construction, the construction should be conducted in a season where the relative humidity of the air is less than 85% and the temperature should not drastically change. Avoid construction during wet seasons and wet walls.
2) During construction, doors and windows should be opened during the day to maintain ventilation; doors and windows should be closed at night to prevent moisture from entering. The wall paper that has just been affixed to the wall is prohibited from being blown by strong winds, which will affect its surface fastness.
3) The adhesive solution that overflows when pasting wallpaper wallpaper should be wiped clean with a clean towel at any time, especially the glue marks on the joints, and it should be handled cleanly. This must be carefully and carefully viewed by construction personnel or supervisors. The construction personnel will keep their hands and tools clean. If they are stained, they should be cleaned with soapy water or detergent.
4) Wallcovering foam wallpaper is easy to accumulate gray, affecting the appearance and cleanliness, cleaning once every 3 to 6 months. Use a vacuum cleaner or brush to scrub with water, taking care not to infiltrate water into the joints.
5) Do not use good wallpaper and pay attention to prevent hard objects or sharp objects from scratching. After a certain period of time, cracking of joints in some places must be subsidized in a timely manner and cannot be allowed to develop.
6) The wallpaper of the bathroom should be opened in time when the water droplets and water vapor are hung on the wall and the exhaust fan should be opened in time. Or use a dry towel to wipe the clean water first, because in the long term, the quality of the wallpaper will be damaged, and white spots will appear. bubble;
7) Too dry rooms should be opened in time to avoid direct sunlight for too long, otherwise it will have a negative impact on dark wallpaper colors.
Maintenance of wallpaper blistering: Wallpaper blistering is a common problem, mainly due to the inconsistent application of glue when the wallpaper is pasted, which results in some internal bubbles appearing in the later period when the surface of the wallpaper shrinks and the base layer separates the water from excess water. In fact, the solution is very simple, as long as the general sewing needle to the surface of the wallpaper to pierce the bubbles, the gas released, and then use the needle to extract the right amount of adhesive injected into the pinhole, and finally the wallpaper back to flatten, dry You can.
The wallpaper is moldy: The mildew in the wallpaper usually occurs in the rainy season and wet weather, mainly because the wall moisture is too high. The solution for wallpapers that are not too bad for moldy conditions is as follows: Wipe with a white towel with a proper amount of water, and then wipe it with soapy water. The best way is to go to a wallpaper shop to buy a special fungicide.
Wallpaper Alice: Edge Alice may be the base layer is not clean, adhesive adhesive strength is too low or the angle of the edge of the wallpaper is less than 2mm and so on, the solution: use wallpaper glue.
Scrubbed wallpaper: Use a damp cloth or a dry cloth to scrub the dirty place; you can't use some colored raw materials to contaminate the wallpaper, otherwise it will be difficult to remove; wipe the wallpaper should start at some evasive corners or hidden behind the door to avoid the occurrence of bad The reaction caused damage to the wallpaper.
Cleaning tips
1, vacuum cleaner;
2, diluted detergent, can also be injected into the sprayer;
3. Spray cleaners thoroughly on the wallpaper;
4, the role of 10 to 15 minutes, the stain from the fiber;
5. While cleaning the wallpaper, use a suction machine to suck the washed wallpaper;
6, let the wallpaper completely dry, in order to speed up the wallpaper dry, you can start the wallpaper dryer
Large-Sized Casting Parts,Ebm 3D Printer Provider,Delicate Metal Castings,Delicate Metal Parts
Guangdong Fenghua Zhuoli Technology Co., Ltd , https://www.fhzl3dpequip.com