After the power-on check is correct, the installation process ends. Test and calibration We have a large number of Japanese Komatsu loaders and a wide variety of materials for loading. In particular, we need to control the weight of loaded trucks in bulk sand and iron ingots. Therefore, we chose the Komatsu Model 89100 Loader as a test model and used the actual working materials such as ore and iron ingots for calibration and testing directly instead of standard weight electronic truck scales as standard equipment.
The automatic weighing machine for loaders does not have to be calibrated according to the verification procedures of the scales. At present, there are no specific verification procedures. First, according to the instrument's operating instructions, set the parameters such as range, division value, decimal places, scheduled load, and alarm lower limit, and then enter the zero calibration. At this point, make sure there is no material adhesion in the bucket. Then the range calibration (or coefficient calibration) is performed. When the meter prompts loading, the material that has been weighed by the truck scale is completely poured into the bucket and the weight value is input to the meter.
After the weighing point test scoops the goods, the instrument display value is compared with the vehicle scale weighing result, and the error is calculated and evaluated. The loader installed a test result of the weighing equipment and the test material was iron ore. The linearity of the loader's automatic weighing instrument is not very good. Therefore, it is very important to properly select the point where the standard object is loaded in the calibration range. You cannot simply select the midpoint or full-scale point of the range, and you should select the most commonly used in the actual operation. The weighing section serves as a calibration point.
A pipe cutting machine shear, historically known as a lever shear and sometimes as a crocodile shear, is a metal-cutting shear with a hinged jaw, powered by a flywheel or hydraulic cylinder. Alligator shears are generally set up as stand-alone shears; however, there are types for excavators. They are generally used to cut ferrous members, such as rebar, pipe, angle iron, or I-beams.
Steel Pipes Shear, Iron Pipes Shear, Metal Pipes Shear, Copper Pipes Shear
Jiangyin Metallurgy Hydraulic Machinery Factory , https://www.eco-balers.com