First, the sprinkler pipe filter is blocked, because the water pumped into the sprinkler cannot all be clean tap water. It may be the dirty pool or the water pumped in the pond. If there are too many impurities in the water, the filter can easily be miscellaneous. Things are blocked, such as sand, plastic bags, branches and other debris, only need to remove the filter inside the filter tee to clean, ensure smooth, you can resume normal work, the location of the filter in the sprinkler Pump inlet pipe middle.
Second, the impeller wear and deformation, resulting in the normal rotation of the sprinkler impeller but can not normal out of water, just replace the new impeller can be.
Third, the water pump seal gap, resulting in air into the sprinkler pump pressure is insufficient, the solution is to carefully check the work of the pump if there is a gap leaking water.
4. The water pump in the sprinkler pump works without water, causing the phenomenon of water-drying in the mechanical seal of the water pump. Replace the mechanical seal.
5. Insufficient power of the drive shaft causes the impeller in the water pump to fail to reach the normal working speed and increase the throttle.
To ensure that the pump has good self-priming performance, the following conditions must be met:
1. Before the pump works, the pump's liquid inventory must be higher than the pump shaft. Therefore, the pump inlet must be connected with an upwardly bent elbow and then a horizontal pipe and quick connector. The quick connector center line must be higher than the pump shaft centerline 300. Mm.
2, the import pipeline system must ensure that no air leakage, sealing performance is intact.
3, suction pipe suction head must be submerged in water, so as not to inhale the water pipe.
4. When connecting the outlet pipe to the pump outlet, it must be ensured that the length of the straight pipe is ≥200 mm and then the bend pipe.
5. There must be a filter tee in the middle of the inlet pipe to ensure that no impurities can damage the pump's precision components before the water enters the pump.
1. The push trolley and geared trolley allow easy installation.
2. For trolleys with a load capacity ranging between 0.5t and 5t, trolley adjustment can be done by rotating the threaded hanger shaft.
3. For trolleys with a load capacity between 10t and 30t, adjustment is possible by turning nuts from one side for the geared type and from both sides for the push type.
4. Crane Parts cast iron wheels with universal tread design to allow usage on the flat or tapered beam flanges.
5. Short headroom design with precision sealed lifetime-lubricated ball bearings assure smooth operation.
6. Durable, all-steel construction with standard safety lugs
7. Geared trolley has as standard the 10ft-long hand chain drop.
8. Both the push trolley and geared trolley meet: ASME/ANSl B30, OSHA, NASA-STD-8719.9, EU Directives: 98/37/EC, ATEX rated II3 GD c IIB 50º C X for limited use in hazardous environments
Crane Trolley,Push Trolley and Geared Trolley,Cranes Trolley
EUROCRANE GLOBAL , https://www.overhead-crane.com