If there is no itinerary, the gasket on the joint surface between the pump body and the engine is too thin. If the stroke is too large, it indicates that the gasket is too thick or the inner arm is worn and should be adjusted or repaired.
If the rocker is working properly, you can remove the inlet and outlet of the gasoline pump, plug the oil inlet with your fingers, pull the hand crank and your fingers should feel suction. If the suction is stable after pulling, maintain 5S Above, you may determine that the valve is good; pull the hand crank and then block the oil outlet, according to the feeling of pressure on the inlet valve to determine. If the valve is not tight, it should be demolished to replace the oil valve.
When the fuel pump outlet out of power, you should check the fuel pump into the gas pipeline and gasoline filter situation. When the pipeline or filter is clogged or the pipeline leaks, it will also result in the problem of weak or no oil.
If the gasoline pump test function is normal, you do not have to disassemble and check, only do a good job of cleaning.
Product Scope:
Dia (mm): 63.5, 76, 89, 102, 108, 114, 127, 133, 140, 152, 159, 168, 178, 194, 219
Length (mm): 170-2800
Executive Standard: GB/DIN/CEMA/SABS/JIS
Advantage:
Our rollers enjoy minimum revolving resistance, low vibration and
noise, good concentricity, long lifetime, low maintenance cost and high
loading capacity.
Material:
Tube: High-precision ERW, welded with DIN2394 Standard
Shaft: Cold drawn steel in accordance with DIN17100 and other equivalent standard, ISO h6 precision
Bearing housing: Cold pressing working, ISO M7
Seals: Labyrinth seal, Nylon 6
Bearing: Deep groove ball bearing C3 clearance
Painting: Ordinary painting, hot galvanized painting, electric static spraying painting, baked painting, Epoxy painting
Idler Roller,Rubber Disc Roller,Impact Cushion Roller,Conveyor Rollers Return Roller
Hebei Juxin Conveyor Engineering Co., Ltd , https://www.juxinconveyor.com